Honorio Bumsrush

Swabbie 
Posts: 50 

 
2169 Gold -

more...
|
Posted: Wed Jun 08, 2005 4:03 am Post subject: Video Card Upgrade |
|
|
When I finally installed a video card, (RADEON9250 256MB PCI bus required which is slower than AGP, but pretty good for the memory size), I had to re-tool the computer a bit. I used the system setup (F1 on boot) to set the video memory for the integrated graphics I was replacing back to minimum (1MB). I had to disable within Windows the internal Intel graphics in Start>Control Panel>System>Hardware>Device Manager>Display adapters>, right click "Video Controller (VGA Compatible)", Disable.
NOTE: Windows Plug and Play will try to recognize the built-in graphics processor on startup and attempt to install those drivers and try to use them instead of the new card and its drivers, until you disable the device; to fix this: Start>Run>msconfig.exe>Services>, click-off "Shell Hardware Detection", Restart, new card and drivers recognized, then disable integrated graphics as described. You can re-check the service after you disable internal graphics.
This setup also recovered 64MG of RAM for the system because the video card relieves the motherboard of processing graphics.
I also tweaked Windows XP startup - this is safe to do, go Control Panel>System>Advanced>Startup and Recovery>Settings>Edit, and edit the file so the Windows load line looks something like this:
disk(0)rdisk(0)partition(1)\WINDOWS="Microsoft Windows XP" /fastdetect /pcilock /kernel=ntoskrnl.exe /3GB /userva=3006
Useful link: http://support.microsoft.com/default.aspx?scid=kb;en-us;833721&FR=1&PA=1&SD=HSCH
In particular, the "/pcilock" switch changes from Windows configuring PCI memory use dynamically to having the basic in/out system underlying Windows to do it statically for the hardware (system stability).
Greatly enjoying the game and many scenarios. _________________ Baron Captain Honorio Bumsrush, boardin' ye'Royal Sloop The Writhing Jackanape. |
|